Quote:
Originally Posted by B44&501xRacerEX
Nice DCM 
And a note on the ballstudds they will bend but not break. I have
never snapped the heads off they just bended on me.
The other studds that came with my 501x with the holes in them
are much better. I did my 501x like that and have never had
a problem with breakage.
I'll include a pic. They are used on the aluminum caster blocks. Put these on the whole car
and you'll never have a problem again. I dont know if you can buy the screws seperate or not.???
My 501x WCE came with a boatload of spare screws... |
Well, I
broke one on first test run. Part of it was still in caster block. Had to drill it out...
Ball studs #53969 are good stuff in my opinion.
Ball studs #19804205 are crap.
On caster block I now use screw and ball nut #53869 (same as on rear hub)
On uprights and steering linkage #53969