i asked cain at rcmodelimports about 4 weeks ago whether these ends would fit as i had already thought of that, this is the reply with my question below it...
they will be to small for what you are wanting to do.
cain
On 30 May 2010, at 23:58, jed wrote:
>
> hi cain,
>
> by the looks of these blaze tc driveshafts they are smaller than the blaze st ones
>
>
http://www.rcmodelimports.co.uk/com/...oducts_id=2682
>
> but could you let me know if the bit from the universal shaft to the threaded shaft the wheel goes onto is the same size as the ones on the st,
>
> asking as i have BLACK lrp driveshafts on my lrp shark at the moment and was thinking of getting some of these so i could strip them down and just use the bit from the uv joint to the thread on my original shark ones, as these are black too and cheaper than the lrp equivilent and when the shaft breaks its normaly only the threaded bit needed, the rest of shaft is normaly ok from the uv joint to the outdrives..................
>
> i hope you understand what i'm saying, lol
>
> this is the bit i mean.....
http://www.lrp.cc/forum/download/file.php?id=26