Quote:
Originally Posted by Ross
Engine,electrics,fuel tank and centre diff out,spray with muc off and jet wash it, once you've done that,if you have access to an airline, clean the excess water off and then place in a warm area to dry the moisture out. I've been doing this for about a year now on my MBX6T with out any problem's.It then gets striped down to check diff's are ok and any bushes need changing and rebuilt.
As far as dirt in the bearings go, i never had an issue with this.
|
+1 on this, been doing the same with my X2 for a year now and all still good (hose not jet wash), I also soak the car in GT85 leave for a while then air line it again, using the gt85 to drive any water out too! Feel this is better than keep stripping car as it wears out screw holes etc!