Hi All,
Did this a while back while trying to figure out some cad software. I was going to make it but got an X6 conversion instead.
Its been sitting in my junk folder for ages so i thought I would dig it out and put it on show for your amusement.
Designed to use b4 front end and b4 gears (additional idler), drive shafts, shocks, arms etc. custom gear casing chassis, shell, wing, other bits. only half done really.
Basically its an X6 on a carbon plate chassis.
If I get the urge to do more stuff I think i would address the B44 balance issues. maybe some chassis plates that shift the motor toward the center of the car more.
