Macnum Brushless problem
Hi guy and forgive me if this question has been asked before but i can't find it and am new on this forum.
Basically i have an Ansmann macnum and have converted it to a brushless system.
It has anezrun 35a 9t set up in it.
The first time i ran it the diff melted the main gear.
Replaced gear but have had to tighten screw that tight that it has almost locked the diff as it just slips.
ran it tonight and it kept stopping but the motor and slipper clutch where rotating as normal.
When stripped it down found that i have stripped the teeth on the centre gear.
does any one run a similar system and had same problem.
Is there any mods i can do to over come these problems i.e metal diff.
Thanks for looking Ste
|