I THINK this is Kev's latest starting set up..
Rear
Red spring with compensator spring
middle hole on wishbone (thats with the longer shaft, may need lower hole)
Additional 57 hole in piston (standard one is about 57 also)
25-30wt oil depending on temp
Hubs high
Roll bar in short link (rear hole in wishbone)
wing forward no gurney- see picture
toe-in 3 degs
1 deg camber
ride height - 21mm (which is wishbone just below level)
max droop (measure with shuey mini spikes) - 45mm
Front
Spring - Yellow
Additional 57 hole in piston
Oil 30-35wt
ball joint done up on shock just showing thread
push rod turnbuckle - 34mm - mounted on top of yoke
top wishbone fully back (max caster)
ride height 19mm
max droop (measure with shuey mini spikes) - 40mm
Roll bar in short link (front hole in wishbone)
camber 1 deg
Slight toe out
Extras
Motor Tekin Redline 5.5 geared on 18/72
One-way shaft
Bumper cut down to improve ground clearance on landing jumps
Cone washers used on front hub ball joints to prevent them popping out of position
Hope that helps
|