Ok guys, first, i would like to say i thought this mod would be made in no time
.
Parts list.
*BJ4 TRANSMISSION SPACER (4) #1030 (5mm)
*AE RC10B4 Wingmount screw 4 of them, Not sure about the length
*AE GT2 crushtube 1
**AE B44/BJ4 batterypost <--This one will be needed if you do not find a extra long screw for wingmount. Or similar, you will do some cuting in this and be using the threads..
The easiest thing is to find 1 screw that is longer then stock Wingmount screw, mm or inch does not mathers, just rethread that in the motormount if it is mm, if you do this, this mod will be done in no time
You will use stock topshaft, but it is real tight, the outer plate does almost getting no grip on the shaft...
When you mount 3 of the long Wingmount screws they will be little to long, they have to be cut a mm or so, this you have to see for ya self. Do not forget the spacers, do a "test mount" before cut.
For wingmount, you will have a extra long screw, the "stock one" will not fit if you will use a regular spacer here...Thats why i using the Batterypost , cut to same length app as the spacers.. But later on this one..
So you have a long screw that will fit, just mount everyting no threadlock, yet..Time fit GT2 crushtube on topshaft...Mount inner slipper plate. Now this is the tricky part, it is little to long, a dream would be a shaft that is 2-3mm longer, but we do not have that, so when you mount this togheter the outer plate will not touch the topshaft...and will not be centrated...I took out the inner plate, the edge on plate facing tranny, there is a tiny,tiny little edge, sand this one down, app 0.5mm or less, you will se the edge, and understand, just take off the little "edge" when this is done, you can make it fit, it is on the "hair" that it works, but i does. Cut one coil of spring...Attach the slipperplate inner one,pad,gear,pad and outer slipper pad, spring and nut. You have to help the outer plate little to get in center position, it have not much "grip", but it will work..
If you do not find any extra long screw, we will using the batterypost... cut it in same length as the spacers, but be sure to have enough with threads in it, cus we will cuntersunk this hole in Motormount, from the spurgear side, and using a short sunked screw maybe you have to cut it, just so you can make it attaced to the mount on the other side...OBS, you have to sunk it, good, and maybe drmel of the head, otherwise the iner slipper plate will touch this one..it is that close. When this is done, and mounted, you can use the stock wing mount screw if you drill out the outer wingmount, like cuntersunk it, a few mm...but my tip is to get longer screws...i will do it.