Hi, try this.. It's actuall really quick when you've got the hang of it.
Take the 4 screws out holding the gear box top down
Remove the screw from the brace on the motor clamp
Remove the lower screw from the carbon rear tower
Tilt the whole gearbox top assembly back(it will twist the turbuckles)
Lift the propshaft assembly and pull rearward to extract it from the front gearbox
Undo slipper nut and remove along with washers (note orientation of washers)
reassemble in reverse order.
It's worth sitting the rear of the chassis on something (I use a wheel) while doing this as its easier to manage. Also, once you have finished make sure you re-adjust the turbuckles so that the balljoints don't rub in the hub top link.
Hope that helps... I think I got all the steps in there.
|