Quote:
Originally Posted by MikePimlott
The only thing in the slipper housing thats an issue is that if the slipper cover / bearing clamp is screwed down too tight it can crush the bearings. (this would cause friction in the bearing and therefore heat)
There is a mod where you can remove material from the plastic cover to prevent this but i havent done it. Just dont overtighten the top 4 screws.
|
I have taken a bit more off the 4 screws and a am going down to a 20T pinion.
Ps, After your set up tips I made my first A final since getting back into racing, at Southport last weekend. bar the heat the car was 100% I just have to get used to driving a very fast car now.
Thanks Mike