Quote:
Originally Posted by Welshy40
Iso,
rear ujs need to be level and rear hub use the bottom middle hole on wishbone. Front wishbones level. Im finding that the zx and zxr setup doesnt work at all and this needs to be high to work well. Front and rear need to be the equal height off the ground with batts on board but do rekon a brass lipo tray is needed so hope to see mine sometime soon. Im using four degree front hubs and zero degee on the rear pivot pin plate.
|
thank welsh but i havent ordered the chassi yet shall do it later.
Any way i have sended fibre-lyte one of my alu motorplate to have it copied in carbon. When they can dulicate it in carbon I shall order it and the chassi/upperdeck.
On the steering posts do you use the ones to screw it together with the topdeck as per manual??? or do you use the optima version with the c-clip ???
mvh isobarik