Just spent the last day or so giving my new ZX5 shell around 4 coats of liquid mask. Drew my design on the outside protective film then started cutting out the first areas of mask............
Even with a brand new scalpel blade it just tore the mask and lifted it away either side of the cut 3-4mm which would just allow bleeding
Have just finished re-masking it with tape on the inside after peeling all the liquid stuff off. Might get the odd bleed but at least it will be done in
time.
Any ideas where I went wrong? Mask was well cured. Brand new blade. Was looking forward to trying this method for a change. Inferior liquid mask even?