Quote:
Originally Posted by the pitman
I might be doing somthing wrong, but should the red led flash on corys i-lap sensor when his car is switch on?
Am i the only numpty that cant work this out, help me Please ....
|
All Transponders were checked to make sure they all work which they did. When connected via the receiver the unit does in fact flash red to confirm power to it.
I would suggest trying an alternative receiver slot if you have one available. It could also be that the slot you used has now power to it. We noticed last night that Steve's 1:18th scale car also had problems when he connected the PT, but this is down to no power from that slot.
Steve will be buying a Y connector lead so othat he can pick up the power from one of the existing slots which are being used. Before you panic try the following...
Disconnect the servo lead that goes into the receiver and plug in the PT. Power up the car and you should then see the red LED flash. If this happens then the slot you were using has no power and you'll need to get a Y connector which I know Russell is ordering a few more.
Hope this solves your problem.
