I spray faskolor about 30psi and thin with Tamiya acrylic thinner a little. White and some other colours might need more thinning than some. I use an iwata with 0.3mm needle. I think a bigger needle would be better for faskolor but I'm happy with my results.
I should say that I spray the fluro colours in several thin coats - they're very thin and if you try put on too much colour it'll just run.
__________________
If your PM doesn't at first succeed - try, try again. I'll reply in the end, honest. 
Last edited by jimmy; 02-01-2010 at 12:31 AM.
|