To protect the LiPo (which is only 110mm long) I'm going to use a block of plastic, such as Delrin or a resin, then drill and countersink the chassis, and screw it on. I've also used velcro tape to prevent the LiPo from sliding, and velcro straps. The blocks are a more permanent solution so I don't have to use the velcro tape. I may try and get the connector in the block too - to look as neat as possible.
Underbody pics to come when I've finished the wiring job - 'cos it's quite complex under there at the moment.
Thanks for the praise guys.
__________________
|