My iCharger 106B+ arrived at last yesturday from Amain after being spanked £22.38 duty £8 of that parcel force fee!! DOH
Oh well, made up a harness as per the diagram on that site Marvin (2s + 2s: Lipo with typical connector) and all seemed well. As the manual is on a disc I had to wing it and it seems fairly straight forward.
It charged the two stick pack lipos in balance mode I set the rate to 10amp (2 x 5000mah packs did I do right?). It put in about 3000mah in total into these new Interllect packs all good. It did however take along time to balance them up maybe an extra 30min showing 1 cell that was down over the other something like 4.20v 4.20v 4.20v 4.17v. Is that normal to happen it did get upto 4.19v before I had to call it a night and swith it off?
Otherwise seems like a nice bit of kit and pretty small too.
