SpeedPassion & V3 motor Issue
Played pit bitch on Sunday for pal with the Durango
Electrics were installed much as the pics in previuos posts
Make sure the motor leads aren't touching / pressing the sensor lead were it plugs into the motor. Tried all sorts to resolve a cogging issue with the new esc / motor combo by retuning to tranny, throttle dead band, esc tune via programmer. Not until R4 did we cure it by routing two of the motor wires over the prop shaft so they didn't touch the senor cable. Think he's going to fit smaller wire dia and a mm or two longer so they have a bit more flex so as not to foul the sensor lead in future.
So R4 came and he didn't have to clean a run but still put on pole in the A. In the final he just drove away from the field.
Never touched the car setup that Hulk uses with mini-pins and just ran it as was.
Two screws backed out of the camber links as they hadn't been thread locked in.
Drive shaft pin popped out. Pushed back in and stayed put.
Motor as per kit geared on 21/87. Motor and esc temp OK. Maybe go down one or two next time out to see haw it goes.
|