Not got a manual but this should help
1) Hold down the button on the back of the transmitter and turn it on. The power light on the transmitter should flash.
2) Hold down the button on the receiver and turn it on. Wait a second or two and let go. The receiver light should flash then stay either on or off. If it's ON press the button again to turn it OFF and you should now be able to control the servos from the transmitter.
3)Hold your throttle and steering where you want them to be and then press the button on the receiver again to turn the light ON. (assuming brakes on, full left)
3)Turn the receiver off. Turn the Transmitter off.
4) Turn the Transmitter back on, turn the receiver back on. The car should now go into it's normal operation and perform it's failsafe for 2 seconds at the settings you chose.
5) Test by holding throttle full on and turn the Transmitter off. Throttle should cut and the car should steer left.
Hope this helps
Andy
__________________
|