Quote:
Originally Posted by T4miy4 Guy
Just after some advice regarding the double slipper!
I have this fitted to my DB-01 and the front and rear diff`s are upgraded to 501 out drives with ceramic balls.
From a hard start off the line at full throttle my DB-01 pulls frantically to the right... is this the fact that the slipper is set wrong ie to lose or is it that one of my diff`s is to lose or to tight?
Any advice lads?
Cheers Andy
|
The double slipper won't do this since it is a drivetrain part. Look to your diffs or your tires for the problem..
Your right wheels must be adding more traction than the left.. A problem with your diff could explain this.. A few causes that comes to mind are:
- One of the diff plates is slipping while the other is not
- The wrong grease or too much grease was used
- The diff screw has become bent
Your tires can also be at fault if they were glued uneven causing one of them to break free.. Uneven wear on the tires could do this as well - say if the left one was very worn while the right one still had good tread.
Check this stuff out and you might find your problem.