soldered them on upside down. I'll remove the top deck so you can see easier when I get home.
When I ran the GTB I had the motor wires between the speedo and the servo. the case of the servo held the wires in place so they came out and did 180 degrees then got held between the 2 and then ran under the shaft. that was with the SP v3.0 motor so I had the plugs to help with that. I wouldn't have thought coming up and being soldered on from below would be too hard though.
The GTB has solder tabs so if you fancied it you could swap them onto the otherside. Since the one I had was my dad's I didn't change them.
|