[Colinevan]

Originally Posted by blitzboy

the clearance on the cvd /drive shafts is fine mate that x6 squared all over , on the rear hub and ball jiont if your running b4 rear huhs you ll be fine too

as for the front steering arms not clearing the wishones again that will be fine dont forget if your turning a right corner for example its the opposite side thats taking the cornering pressure and the steering arm will be at full turn on the right and against the wishbone ,,,this will not make much difference buddy as the insde wheel in a corner does help with initial bit as you turn in

the steering arm is in the lower position at the which will give you good steering .... if its too much just set at the middle to ease it off ,,, hope that helps mate ,,,, im sure some of the full x factory drivers or darren will add some more light on other bits mate

tp lipo 4900 25c will be good too buddy

Excellento , thanks for the advice.