Slowly progressing the build of my DB01-R, but have run into a snag.
I didn't really pay any mind to it, but now that I have come to assemble the suspension I notice that the diff screws seems to protrude too far out into the outdrive. About 5mm or so.
This provides no space for the drive shaft to sit properly inside the outdrive as it hits on the diff screw! In fact, if I insert the red foam piece into the outdrive as per the instructions, the drive shaft won't slide in at all!
I have the thrust race in, and the spring. What gives guys?
Cheers,
Scotty P.
|