Build like you've already done, oil to the top, put the cap on loosely, push the shaft in all the way slowly or 2-3mm from full in (to the start of the thread / ball cup). With the shaft pushed in (all the way, or 2-3mm - depends how you like it) screw the cap on the rest of the way.
You can use the bleed screw to do the same thing if needed and if you've 'activated' the screw - but the cap is just as good really.
There is supposed to be air in there - you've got too much oil if you can't push the shaft in.
__________________
If your PM doesn't at first succeed - try, try again. I'll reply in the end, honest. 
Last edited by jimmy; 02-10-2009 at 01:59 PM.
|