Quote:
Originally Posted by sosidge
What I mean is that if you run the long body on the front end you will have no suspension compression over the bumps as the shock will bottom out long before the chassis does.
|
Hey, I have just installed the LAW34 kit and found the kit did not increase the height at the front (the arms are the same as standard), so I used these shock ends in the link below and cut 3mm off the ends and it raised the front about 5mm. It bottoms out the chassis before the shock but only just, I had to move the shock position on the tower and the arm to the inner hole. I have noticed that the kit raised the back of the car about 5mm or so which is good, but also noticed that the rear uni shafts are so very close to falling out of the outdrives at full height. I will find out if I have any trouble with them popping out at next race meet, but should be an easy fix if I do.
http://www2.towerhobbies.com/cgi-bin/WTI0001P?&I=LXWZ65
Hope this helps
omen1975