Hi if any one is interested this is Grants set-up from RHR this weekend
Blyth RHR National finished 3rd
Front -
Track Washers - 1mm front and back
Roll Bar - No
Shock Position Mount - Middle
Shock Position Wishbone - Middle
Front Rake - 10 Degrees
Washers - 0mm
Front Link Bracket -38.5mm
Washers on Hub - 0
Rear -
Wheel Base - Short
Toe In - 3mm Rear, .5mm front = 3.25 degrees
Anti Squat Washers - 1mm Rear, .05mm Front =.065 degrees
Rear Link Bracket - 37.5mm
Washers - 3mm
Shock Position Mount - Middle
Shock Position Wishbone - Inside
Hub Position - Middle
Roll Bar - No
Shocks
Front -
40wtt on 3 Holes Drilled 55
Schumacher old Grey Springs
Diaphragm - Centre cut out and removed
Ride Height – Drive shaft level
¾ length ball end total length of shock 85mm
Rear -
35wt on 3 Holes Drilled 54
Schumacher old Red Springs
Diaphragm - Centre cut out and removed
Ride Height - Wishbones level
Full length ball end total length of shock 99mm
Transmission-
Rear Diff Height - Low
Front Diff Height - Low
Layshaft Pulley – Pin out
Front Drive - Diff
Gearing - 81 x 23 on Speed Passion 5.5
Internal Ratio - 36 Tooth Pulley
Tyres
Yellow Mini spike all round ,Mr ‘O’ blue inserts.
7.5 caster blocks
108 grams added
Stiff chassis
Any Questions just ask
Mike
__________________
Retired Racer
|