I had posted a thread about this, in here, but here we go, again.
Front end: buy the B4 axles and blocks, ream the block to 3mm, and you will need a 2mm spacer, so you can now run the axle low or high, and it brings the front width safely inside the width limit.
Rear end: I used a pair of Tamiya DB-01 rear stub axles, trimmed down on the exle side, to clear the wishbone, and DB-01 front dogbones, for now, you will need 1 0-ring in the RHS diff outdrive, and 3 in the left. You will also need the axle washer and drive pin.
Running it like that, the car works a treat.
|