[stebedford]

Ive just bought a Hyper 7 .21 engine for my hong nor x1cr to replace the broken force .32 engine i had. I used the fly wheel and clutch bell off my old engine on my new 1.

When the clutch bell is I cant screw the retaining screw all the way in the end to hold it in place because it locks up the bell because its tight against the bearing, if i dont fasten it all the way in the bell does move but it starts to work its way off and the bell itself starts to come off, is there any way of getting round this? can i get a shorter clutch bell?

Hope that makes sence