Quote:
Originally Posted by Fiddybux
I'm not entirely sure of the point of uploading the image, especially of the comm was freshly skimmed and golden (honest!)...now it appears to be a bit burned.
Anyway here's a pic of the broken brush wire, which I suspect was shoving volts into the outside of the can and messing up my servo (via conduction through the graphite chassis).
And here's the pic of the comm (all a bit burned after about 6 laps)....doesn't look good does it!?!
Bear in mind that the brush wire used to be connected up, albeit with only a few strands of wire connecting it together which I didn't actually notice until after I'd run the race and experienced the problems.
All other tests with other motors so far suggest that the motor is at fault.
Cheers. |
to be honest mate i bin racin for for 26 years dodgy motors dont shag servos i reckon its the gear set
