Quote:
Originally Posted by GAZ
Been having some problems with my xxx-cr used it twice now and i just seem to be cooking motors, so bad that one of the brush shunts desoldered itself. I'm guessing it's down to the copper shims in the diffs giving a litle bit to much slip, I'm going to try it next week without them and just shim the diff on the outdrives.
Has anyone else had any problems with this?
|
What motors are you using, make, wind. also what gearing are you using and what batterys.
The diff shims won't cause your motor to desolder it's self there is some thing else wrong there, more than likely with the motor.