Quote:
Originally Posted by Crazy L
Hi guys
I'm running my Durga with the novak gtb system, however, it's a freaking mess, sensor wire is too long, wires everywhere etc. I want to make it tidier and was just wondering if any of you lot have done the same. If so, any chance of a pic?
One of my other ideas was for going for a low profile servo to clear some floor space, any suggestions?
ta muchos
|
Run the sensor wire to the front of the motor, along side the center cover and position the sensor port on the ESC face to the back of the car. Also, wrap all small electronics wires with the plastic coil wrap that is included in the kit then tie the excess sag with a ziptie to the hollow chamber on the back of the car. Or you can always get a shorter sensor wire. I think they sell that. The way you replace it with Novak motors is to remove the back cover to access the sensor port.
I hope that helps.