Quote:
Originally Posted by bronco
I mounted the E-speed hangers (low) but only to find the turnbuckles being too long.
Did you also shorten your buckles or did you use the outside hole on the rear knuckles. Using the outside hole, does it change alot opposite using the center hole ?
Second, how do you mount the ballstud on the rear knuckles : at rear or at the front of the knuckle ?
Thanks
|
Ive bought the following to get round this!
AE FT 35mm x2 (For inside hole on hub-indoors)
AE FT 48MM x2 (For outside hole on hub-outdoors)
You could even go for 45mm here but they didnt have any in stock when i ordered. 48mm fit fine ou just need to wind them right down and will run -1 camber fine!
The main problem is with the standard b4 rear turn buckles as youve found out is there too long! I tried cutting them down a bit but bent one in a race landing hard due to the limited amount of thread which was inside the ball ends. Do the job properly its worth it in the end!