Cheers Natham
I think we was confusing ourselves on this one, we have built with front diff (same as back) then assembled shaft with one way bearing (cleaver little things)- now the front acts as a one way, or at least my understanding of a one way, receives drive via shaft when going forward, but when breaking, only the rear locks up so to speak, the front freewheels, mind you this is just pushing the car along the kitchen floor, motor still to be fitted. I expect if we change the bearing on the shaft for the fixed plastic part we will have 4wheel drive and 4wheel breaking.
Now, putting the bearings into the front diff instead, how would this change the way the car handles if at all, from what we have.
|