[Chequered Flag Racing]

X-Factory X6 / Rear Hinge Pin Anti-Squat

1 piece shims in Carbon Fibre



Had some made up and been running them for over year now with out a problem.

Just back out the 2 lower chassis screws, undo the 2 screws that hold the toe-in block in place and slip in or remove a new shim to adjust the anti-squat. Kit will include a shim to replace the washers under the screws that hold the toe-in blocks in place. (when using the thickest shim the washers get in the way)

UK £10.50 shipped
USA $23.50 shipped
Europe €17.50 shipped

5 shims for anti-squat adjustment & 1 shim to replace washers used on toe-in bar (not shown)

0 deg = .150" or 3.81mm 0 deg = 3.8mm spacer or (2.3mm +1.5mm)
1 deg = .120" or 3.048mm 1 deg = 3mm spacer
2 deg = .090" or 2.286mm 2 deg = 2.3mm spacer
3 deg = .060" or 1.524mm 3 deg = 1.5mm spacer
4 deg = .030" or 0.76mm 4 deg = 1mm spacer
5 deg = no shims

UK based in the North East.

Have been racing since 1993

BRCA licence holder

PM or email if you want to get hold of some
(add X6 Anti-Squat Shimz to the subject line in email)

send payment to paypal @ [email protected]