the build step has been brought to Ansmann attention, as it is a little 'vague' on the build, this is how I built it
Clean all parts with motor cleaner
Smear a small amount of diff grease on the diff outdrive, where the plates will sit
fit plates
smear a small amout of grease on the outer edge of the plates
assemble the diff pulley/balls/outdrives
compress diff spring before fitting (this makes the diff settle a lot faster)
use Molybdenum Greae (black AE stuff) or Tamiya AW grease on the thrust bearing. (if you don't do this, the bearing will over heat and wear.
Set diff up, should be good
|