Good idea, but I've checked that too. I'm using the rulux wheels for the b44. For these wheels to work in the front, the purple hex must go on after the pin, it is just on the axle loose and not retained by the pin, and the whole mess is retained by the wheel istself. If you put the hex on first, and then put the pin through, like the manual shows, the offset is a hair off and the wheels rub on the hub.
Maybe I should try hex first, pin through hex, and a little washer to adjust the offset, or try some other wheels. I've tried the stock wheels (no hex) and found the problem is still there.
|