I used my remaining CVD rebuild kits on the rear drive shafts so couldn't install them.
I did go as far as removing the couplings from the gearbox and dropping the center shafts in place as a test. The rear shaft is a direct fit. The Cyber 10B's spur gear assembly is the same dimensions as the WCE slipper, so you need a WCE front central shaft. It's slightly shorter than then standard D4 front central shaft.
As well as the shafts, you also need the coupling drives for the gearboxes.
On a different note, I'd be curious to see how everyone is laying out their electronics in the chassis. If you could post a photo up, it'd be greatly appreciated.
|