A question concerning the timing option on the program card.
Changing these settings, does it work in sensorless mode or is this only working with a sensored setup like a Xerun?
I've tried a few changes on my 60A Ezrun + Dr. Speed 12T Delta. Turned the timing way up, but can't see any changes in power output.
Another question concerning power output :
Esc Ezrun 60A burst 380A
Lipo Orion 4800 20C
Dr. Speed 12T Delta 450W=60A
What is the limiting factor in this setup ? Will changing the Esc to a Xerun 120A improve performance ?
|