The car is set up as it came second hand and im new to touring so dont know spring weights etc. I will check shock positions etc when i get home but from memory. . .
3deg toe block rear
1.5deg toe block front
no spacers under anything front + rear
middle wishbone hole - shock bottoms
med roll bar front
about 0.5/1deg camber rear
load of camber front ( this was less but i found by putting loads on car was better probably due to only inside of tyre is in contact even in corners)
3 or 4 holes in from outside of tower - front and rear top shock mount position
Used car indoors on a cork/rubber type surface with rubber 27 and with foams and on tarmac with rubber 24 - same problem, back end looses grip from middle to exit of corner - maybe im too heavy on the sticks??
|