Quote:
Originally Posted by mw02veg
Hi, this is Grants set up from the 4wd regional.
Any questions just ask hope we can help.
Mike.
Front -
Track Washers - 1mm front and back
Roll Bar - No
Shock Position Mount - Middle
Shock Position Wishbone - Middle
Front Rake - 10 Degrees
Washers - 0mm
Front Link Bracket -38.5mm
Washers on Hub -cut 0
Rear -
Wheel Base - Short
Toe In - 3mm Rear, .5mm front = 3.25 degrees
Anti Squat Washers - 1mm Rear, 1mm Front =0 degrees
Rear Link Bracket - 37.5mm
Washers - 4mm
Shock Position Mount - Middle
Shock Position Wishbone - Inside
Hub Position - Middle
Roll Bar - No
Shocks
Front -
40wtt on 3 Holes Drilled 55
Schumacher old Grey Springs
Diaphragm - Centre cut out and removed
Ride Height - Wishbones level
Rear -
30wt on 3 Holes Drilled 54
Schumacher old Red Springs
Diaphragm - Centre cut out and removed
Ride Height - Wishbones level
Transmission-
Rear Diff Height - Low
Front Diff Height - Low
Layshaft Pulley – Pin out
Front Drive - Diff
Gearing - 83 x 23 on Speed Passion 5.5
Internal Ratio - 36 Tooth Pulley kit
Tyres
Yellow Mini spike all round ,Mr ‘O’ blue inserts.
High grip and warm
7.5 caster blocks, ¾ length ball ends all round (shocks)
|
Quick question, on the shocks it says it's go 3 hole pistons drilled to 55 and 54, but what was the other hole? I'm assuming 555 and 544?