This is my current stick pack setup and will be my starting point for the first national.
Stick Pack setup:
Rear
Yellow spring with compensator spring
middle hole on tower
tower reversed to give more droop
New hole in shock mount (more droop)
17mm of shock shaft showing
New Piston (same as additional 57 hole)
30wt oil depending on temp
Hubs high
Roll bar in short link (rear hole in wishbone)
wing forward no gurney
toe-in 3 degs
1 deg camber
Wishbone just below level
Antisquat - Standard brace
Front
Spring - Red
New Piston (same as additional 57 hole)
Oil 32.5wt
3mm internal shock spacer
2.5mm cut off balljoint
14mm of shock shaft showing
New postion on wishbone using blue servo mounts and hole drilled at edge of webbing
push rod turnbuckle - 22mm - mounted on top of yoke with cone spacer also
top wishbone fully back (max caster)
ride height - wishbones slightly sagged
No Roll bar
camber 1 deg
Slight toe out
Front hubs modded and mounted low
Extras
20g under front shocks
5g to space speedo from shaft
2 x 5g to space lipo fromt shaft
Trakpower 4900 - approx 280g
Motor Tekin Redline 6.5 geared on 20/72
Tekin RS Pro mounted up front to get weight forward
One-way shaft
Bumper cut down
|