[Mossy]

A few people have emailled me asking for the setup i ran last week at Southport. For those who dont know the track is high grip and pretty bumpy, multi surface throughout.

Front -

Track Washers - 1mm front and back
Roll Bar - No
Shock Position Mount - Middle
Shock Position Wishbone - Middle
Front Rake - 10 degrees
Washers - 3.5mm
Front Link Bracket - 43mm
Washers on Hub - 0
Front Yokes - 7.5degree alloy, inside hole

Rear -
Wheel Base - Short
Toe In - 2.5mm Rear, .5mm front = 2.6 degrees
Anti Squat Washers - 2mm Rear, 0.5mm Front = 1.95 degrees
Rear Link Bracket - 37.5mm
Washers - 4mm
Shock Position Mount - Middle
Shock Position Wishbone - Inside
Hub Postion - Outside
Roll Bar - 1.2


Shocks

Front -
30wt on 3 Holes
Schumacher Grey Springs
Diaphragm - Centre cut out and removed
Ride Height - Wishbones level

Rear -
27.5wt (mixed Schumacher, not Losi) on 3 Holes
Schumacher Red Springs
Diaphragm - Centre cut out and removed
Ride Height - Wishbones level

Transmission-
Rear Diff Height - High
Front Diff Height - High
Layshaft Pulley - Pin Through
Front Drive - One Way
Gearing - 81 x 24 on Speed Passion 5.5
Internal Ratio - 34 Tooth Pulley

This setup will give you a fair bit of steering.

Si