I'll have some 3rd party Alloy parts to review soon I hope which should beef up the car a little, and bring the weight back up a little!
I need to weigh my car, but with all the Ti screws, Ti Turnbuckles, Carbon fibre, it should be slightly over minimum weight, just.
With an airbrushed shell and tidy wiring I could see how it could be underweight though.
The camber link plates / bulkheads are a bit of a pain, You can adjust the rear ones with a long nut driver, but the fronts are impossible. Its a pain but for a new car its not bad at all, you seem to get problems like weak hinge pin braces / wishbones / shock towers etc crop up on new cars all the time, after all i guess these superstars that develop the cars probably dont crash like me and you! :wink:
I'm sure any weak bits will be ironed out if possible.