The area of the two cell slots is VERY thin at the shallowest part but it should NOT have a hole. This can occur occasionally if the graphite does not fully flow through the mold and we have only seen this on one chassis so far (happened to be one we had sent to Hong Kong!!!) from here in the UK.
At the end of the day the hole is NOT right, but it will not effect performance, durability or stength in any way (since the box section around the two cell slot is what provides the core strength in that area, BUT if you wish for us to swap it over for you then please just pop it back and we will get it exchanged by return of post immediatley.
Darren
__________________
ORCA - LC RACING - RUDDOG PRODUCTS - JCONCEPTS - ALPHA PLUS - TEKIN RACING - ULTRAPOWER
AVID R/C - VAMPIRE RACING - EXOTEK RACING - LUNSFORD RACING - X-FACTORY - TUNING HAUS - WTF
AME - RAGE R/C - REVOLUTION DESIGN RACING PRODUCTS - McKUNE DESIGN - TEAM AZARASHI
X-PARTZ - PHAT BODIES - RACERS EDGE - RM2 - DIRT RACING PRODUCTS - DMS INSERTZ
TKR GRAPHICS - BF MATERIALS - BATAN - DMS PARTZ - TEAM AJ Tel : (01923) 816636
|