Quote:
Originally Posted by omen1975
I will be upgrading my Keen Hawk later using a DF-03 Five Star slipper shaft and use an Associated B4 slipper setup, DF-03 Tamiya upgrade shocks, DF-03 3Racing Titanium turnbuckles and maybe a set of CVD's (universal drive shafts). I used hex type screws throughout my Keen Hawk.
I have also noticed on my KMRC built Keen Hawk that I will have to cut a small hole in the body shell above the servo horn as the servo saver mechanisim touches body so this modification will allow the body shell to sit in its normal lowered position.
I have also designed and made some plastic strips that double sided tape to the chassis along with some clear undertray protection sheet, this will allow me to throw away the clips that normally hold the shell on and use velcro instead. (pictures attached)
Hope this helps.
omen1975
|
But there are no any stickers on the rear wing. Just leave it blank?
And only the keen hawk body will touch the servo mechanism but not the Dark Impact body, won't it?