[niggs98]

hi all here is my setup from the EIR race belgium

front

springs blue (no compreision spring) 5 1/2 turn in older style
oil 40wt losi
piston 2 x 0.96 holes, no rebound valve
pushrod above rocker + cone washer
pushrod lenth 23mm with shockball undone 1turn + new lower mounting point (pm me an email addy for a picture to explain)
standard front arms with 0 washer behind wishbone
no washer under outer point hub standard height
roll bar 1.2mm (standard) in stiff position
ride height 19-20 mm
front wing kit with standard lines followed
0 degree toe in/out with 2.5 degrees of camber + 2 mm washer under outer steering point to remove bumpsteer

rear

springs white with compression spring
oil 35 wt losi
piston 2x 0.96 holes
middle hole on shock mount
roll bar 1.2mm in stiff hole in lowered position (pic to follow)
wheelbase standard
extra droop hole used but with ball joints wound on fully (half way between the 2 holes )
ride height 22mm
large rear wing with half guerney
toe in to middle of front wheel
rear uprite in lower hole

shumacher yellow minispikes with outside and inside row cutoff rear and 2 inner and 3 outer cut off front. mr O inserts used

any extra info you need feel free to ask or pm