Quote:
Originally Posted by super__dan
With all the Losi cars you must the right combination of wishbones and hubs. I used to run a XXX4, other than the original hubs and wishbones your options were to run the BK2 rear wishbones and hubs, but you HAD to run them both. If you did you could run the long or short VLA with no change to the width of the car so the driveshafts shouldn't mover. Note that the XXX4 rear geometry was not the same as the XXCR.
You can't run the BK2 stuff on the XX4 or X5 becasuse it is based on the XXCR back end. Hence becasue the inner toe in blocks are in right place you CAN put the XXXCR wishbones AND hubs becasue they are based on the same inner toe in points.
To run the XXXCR hubs you 'must' cut the inner set of holes off using a dremel or whatever, that way no ballstub washers are 'needed'. Personally I now run the new hubs in the D hole which is the 2nd outer (1/2 outer?) hole with no washers. That combined with going 1 hole further in (longer) on the tower link position has really helped lock in the rear end for me.
|
That's really interesting Dan...but I'm finding it a little difficult to visualise. Can you post a pic of yours for us?