Front - 35 wt - Blue Springs - 2 hole pistons, inside hole on shock tower and outer on wishbones
Rear - 30 wt - Silver springs - 1 hole pistons, middle hole on tower and outer on wishbones
Front turn buckles - Inside on tower with 1mm washer under ballstud, inside on hub (Long link)
Rear turn buckles - Outside on tower with 1mm washer under ballstud, middle on hub. (Short link)
Middle wheel base (Or short, i've not tried that yet!)
2° Anti squat
Battery in middle
Jconcepts 6.5" full back wing
Schumacher yellow mini-pins front and rear
Plastic chassis (It doesn't make that much difference thoguh if you are running a graphite one)
10g lead under the front nose
40g lead in front of the servo
160g lead sheet under the whole of my lipo (Not needed if your running Nihms)
40g lead in rear bulkhead
Make sure you do the turn buckle settings as well, they are much more essential than you think!
|