I run a b4 with a novak brushless! heres how I made it fit:
the main wires and shoky face the front and the switch faces the rear.
The body of the esc is tilted towards the centre of the car, by placing a small piece of plastic under the esc and sticking it down with double sided tape.(just use anything that will make the esc tilt about 10-15 degrees)
The shell has to be modifed too: at the back of the shell cut a small half circle about the size of a 10p. (this is for the 3 main wires to go though and inbetween the rear shock towers). the shell is linned with velcrow as is the chassis of the car. in order for the shell to fit onto the body it will also have to be stuck to the body with a slight tilt.
I'll post a pic up next week
its a tight fit but it can be done!
Craig.
__________________
Brushless B4.
|