Quote:
Originally Posted by Cassp0nk
Just guessing here, but did you follow the upgrade instructions and send the reset through to the controller? Also you shouldn't install on top of a previous installation, you should remove that first. So no don't use the driver disk.
|
Got the software working OK. Had to get the USB drivers off the disk though. Did do a fresh install. Just think it got its knickers in a twist with AVG etc
All that works now.
However, if I upgrade to 128 I get no consistent reverse, but everything else works well. Tried callibrating with the transmitter over 10 times, and still no joy.
If I swap back to 125 firmware everything works fine again, like it did before. As soon as I go up to 128 I lose the reverse. Sometimes it comes on if you bang the stick back, but most of the time it just goes to brake.
I think it must be to do with the breaking modifications they made with this firmware, and it is like there is now not enough stick travel to get it to reverse. I don't know.
I am back running 125 for now while I'm bashing around, but the spike voltage cut-out is annoying.