Lowering the inner front camber link increases bite, as does raising the outer. By cutting the hub you are lowering the outer ballstud to decrease bite, but we also raise the inner to 0mm shims to further increase the same effect given by cutting the and lowering that ballstud. This does not cancel each other out.
If you do one side at a time, you will see the drastic change in the angle of the camber link. From kit the angle is very severe in relation to the wishbone, whereas what we are aiming to achieve is that camber link to be much closer to parallel to the wishbone.
Chris
__________________
JESpares JESpares JESpares JESpares JESpares
www.jespares.com
|