[steveproracing]

Hi buddy
dont use a servo saver they just create an unpredictable steering response.
you should have a near silent mesh! It sounds like you have either a faulty pinion or spur. Not a problem though i will happily give you a new one at bury.
as for your wiring running signal leads under the ariel mount is fine, but make sure your power/motor leads are away from them.
as for your Brushless cutting out i am only guessing. It it set for lipo if so and your cells were not charged that could be the lipo fail safe kickin in. Also just check your wiring, in particular if your Brushless has a sensor lead make sure it has no breaks in it and is properly connected.
I am sorry if i am teaching you to suck eggs though.
if you need any help(and a pinion) come and see me at bury next week.
Hope this helps
steve